Chrysler Grand Voyager - Oil light comes on then cutting out - Cyd Most pressure switches will operate at around 5-7 psi. Obviously the running oil pressure will vary from engine to engine, but in the absence of model specific information I'd be looking to see at least 20psi at 2000rpm at normal operating temperature. Select the Chrysler Grand Voyager model by engine capacity, fuel type and performance for service interval and maintenance information. Chrysler Grand Voyager 2.4i (Petrol, 147 HP, MT) 2004 - 2007 Chrysler Grand Voyager 2.4i (Petrol, 147 HP, AT) 2004 - 2007 Chrysler Grand Voyager 2.4i (Petrol, 147 HP, MT) 2001 - 2004 Chrysler Grand Voyager 2.4i Cabin air filter on Chrysler Voyager is located inside the car on the passenger side. To have access and to replace the cabin air filter on a Chrysler Voyager follow the next instruction. On the passenger side look under the glove compartment. Look under the glovebox to locate sliding bracket and filter housing cover – see picture. Location:: Oil FilterInside Thread Size: 3/4 In. - 16Filter Media Material: 2000 Chrysler Voyager Perf Oil Filter Remote Mount Kit; Show Less. Related Makes. The most common causes for AC not cooling properly in Chrysler Grand Voyager are low or overcharged refrigerant, compressor malfunction, clogged cabin air filter, dirty condenser or evaporator coils, dirty or sluggish blower motor, and bad fuse or relay. Less common causes are clogged expansion valve or orifice tube, overcharged oil, faulty . Timing cover oil leaks do also affect Chrysler models with the 3.8 V6 engine. Anyways, the issue at hand is the o-rings within the timing cover. Faulty o-rings within the timing cover can crack, deform, break etc. This causes an oil leak to develop from the timing chain cover. Look for visible oil leaks in that area. Replace oxygen sensor. oxygen sensor is located in the exhaust pipe just as it leaves the engine, it monitors the exhaust gas as it exits the engine, look down between the back of engine and the firewall. peek-a-boo ! some cars have (2) one @ the exh. pipe before the CATalitc converter. use a 7/8 " wrench, wd 40 will help also. tight is tight 8. Add or remove oil as necessary and recheck the oil level. 9. Once the oil level is correct, install the dipstick tube cap. Applicable Models: 2007–2008 Chrysler Pacifica; 2007–2010 Chrysler Sebring; 2011–2014 Chrysler 200; 2008–2014 Dodge Avenger; 2008–present Chrysler Town and Country; 2008–present Chrysler Grand Voyager First of all, for the filter, PLEASE, PLEASE, use an original Mopar/Chrysler Parts filter. These engines experience oil leaks that require the owners to take them to the Dealers for service. The Dealers then replace the oil filter housing part which is then tested at FCA with 70-80% passing with no leaks. OBD2 Sensors. >> Chrysler 3.6L PENTASTAR V6 ENGINE SENSOR LOCATIONS. View with engine cover installed. 2012 Jeep Wrangler 3.6L PENTASTAR V6. Camshaft position sensor Bank 1 (CMP) (located at the back of pass side cylinder head) Camshaft position sensor Bank 2 (CMP) (located at the back of driver side cylinder head) Oil pressure sensor (top of

chrysler grand voyager oil filter location